Problems With Plumbing? Check Out These Great Tips!

If you know absolutely nothing about plumbing and are just dreading a day when the pipes in your home may burst, you need to read this article, which contains numerous tips that will both inform you and ease your mind. Read on for a comprehensive list of solid plumbing advice.

If you discover a pipe has frozen, open a tap on the line to allow the thawing ice to drain. If there is too much pressure within the pipe, it may burst, causing other forms of damage in the home.

If you have noisy pipes, you can cushion them with a rubber blanket or add additional anchor straps. Banging pipes are usually caused by loose pipes, water hammering to a stop as you turn it off, or hot water pipes shifting in their position. All of these problems can be solved by cushioning and anchoring the pipes.

Check your faucets for leaks. Check the knobs and the faucet itself. Hundreds of gallons of water a day can be wasted due to leaks and that’s not good if you’re paying your water bill. By stopping a leak now, you can save yourself a lot of money. Leaks can grow over time as well, so avoid a disaster and check all faucets for leaks!

Never pour grease or anything fatty or oily into your drain. These materials may be liquid when you pour them in, but they will solidify and cause problems. Especially if you operate a garbage disposal, the fat causes blades to be less efficient. Don’t put oils down the sink.

Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

If water backs up from one sink to another, it is because the lines are connected. The part of the branch line for one device might be higher than another, but most likely there is also a blockage in the branch line connecting the two devices as well. This blockage must be cleaned.

Hopefully, now that you’ve read the above tips, the fine art of plumbing is a little less scary to you. Remember what you’ve learned here, so that you can put in practice when you need to. Also, remember that when all else fails, a plumber is just a speed dial number away.